Assessment of liquefaction potential of Firozkuh sand Amended with crumb rubber under cyclic simple shear loading
Assessment of liquefaction potential of Firozkuh sand Amended with crumb rubber under cyclic simple shear loading
آزیتا باقری1 امیرحسین اقبالی2 نوید هادیانی3 مریم حق بین4
1) دانشجوی دکتری عمران گرایش ژئوتکنیک
2) استاد یار دانشگاه آزاد اسلامی واحد اسلامشهر و
3) استاد یار دانشگاه آزاد اسلامی واحد اسلامشهر
4) استاد یار دانشگاه آزاد اسلامی واحد اسلامشهر
IOI Code
:
AACH-ABHBAC
Publication :
7th.International Conference & 8th.National Conference on Civil Engineering, Architecture, Art and Urban Design(8iccacs.ir)
Abstract :
Liquefaction of saturated sandy soils is a major geotechnical hazard during earthquakes. This study experimentally evaluated the effect of adding 0, 10, 15, and 20% crumb rubber by weight on the liquefaction potential of Firoozkuh 161 standard sand using a cyclic simple shear device. All tests were conducted under saturated conditions (B≥0.96), effective vertical stress of 100 kPa, relative density of 30%, and cyclic stress ratio of 0.15 at 1 Hz frequency. Excess pore water pressure (Δu) was continuously recorded, and the liquefaction criterion was defined as Δu reaching 95% of initial effective stress. Results showed that pure sand liquefied after 12 cycles, while samples with 10, 15, and 20% crumb rubber liquefied after 22, 31, and 29 cycles, respectively. The normalized maximum pore water pressure decreased from 0.98 in pure sand to 0.85 in the 15% rubber sample. The rate of pore pressure buildup decreased by an average of 40% in rubber-amended samples. The 15% rubber sample exhibited the best performance with a 2.6-fold increase in cycles to liquefaction. Overall, crumb rubber effectively reduces liquefaction risk in Firoozkuh sand through pore pressure control and energy absorption mechanisms.