Investigation of PCD tool wear mechanism in dry machining and MQL mode in the Si3N4 ceramic turning process

Investigation of PCD tool wear mechanism in dry machining and MQL mode in the Si3N4 ceramic turning process

mazaher aghdasta1 mohammad reza shabgard2 ayub karimzad ghavidel3 hadi eyvazi bagheri4

1) Ph.D. Student in Mechanical Engineering – Manufacturing and Production, University of Tabriz
2) Full Professor, Department of Mechanical Engineering – Manufacturing and Production, University of Tabriz
3) Assistant Professor of Mechanical Engineering- Manufacturing and Production, National Skills University, Tabriz
4) PhD Researcher in Mechanical Engineering -Manufacturing Engineering

IOI Code : AAHD-ABKDDC
Publication : National Conference on Information Technology, Nanotechnology, Artificial Intelligence and Technological Futures Studies(itnaf.ir)
Abstract :
    Advanced silicon nitride (Si3N4) ceramics are widely used in various industries due to their high hardness and exceptional resistance to thermal shock; however, their machining is very complicated due to the generation of intense heat in the cutting zone and a sharp reduction in tool life. The main objective of this study is to investigate the effects of dry machining and minimum quantity lubrication (MQL) with a water-oil based nano-fluid on the flank wear of PCD tools. The mechanisms of tool wear under the aforementioned conditions were investigated to explain the wear behavior and identify the dominant mechanisms of tool wear. The results showed that in dry machining, due to the high temperature and the lack of ceramic abrasive powder ejection, severe three-body wear and edge chipping prevail. In MQL machining with a nano-fluid, due to the formation of an abrasive grout in the presence of a water-oil phase, the flank face wear rate reached its highest level with a 150% increase compared to the dry mode. The findings prove that in the MQL machining mode with a base fluid without tribologically improving nanoparticles, due to the formation of active abrasive grout in the cutting zone, it causes a severe reduction in tool life; therefore, in the process conditions studied, dry machining provides a more optimal performance in controlling flank face wear and maintaining the health of the tool cutting edge.

Keywords : silicon nitride (si3n4) pcd tool nano based fluid tool flanke wear