Cyclic Nonlinear Static Pushover Analysis and Determination of the Behavior Factor for a Single-Story, Single-Bay Intermediate Steel Moment-Resisting Frame Using Chopra’s Method and Abaqus Modeling

Cyclic Nonlinear Static Pushover Analysis and Determination of the Behavior Factor for a Single-Story, Single-Bay Intermediate Steel Moment-Resisting Frame Using Chopra’s Method and Abaqus Modeling

Mohamad Sadegh Shahidzadeh1 Alireza Derakhshan Nezhad2

1) Assistant Professor, Department of Civil Engineering, Faculty of Engineering, Khatam Al-Aanbia University of Technology, Behbahan, Iran,
2) M.Sc. Student in Civil Engineering (Structural Engineering), Department of Civil Engineering, Faculty of Engineering, Khatam Al-Anbia University of Technology, Behbahan, Iran,

IOI Code : AAHE-ABHFHH
Publication : National Conference on Civil Engineering, Design and Construction Technologies, Energy, Materials and Advanced Machinery(icaeu.ir)
Abstract :
    The objective of this study is to determine the behavior factor and ductility ratio of a single-story, single-bay intermediate steel moment-resisting frame using cyclic nonlinear static pushover analysis and Chopra’s method. To this end, a 3D model of the frame was simulated using the finite element software Abaqus. The sections were defined using ST37 steel with a density of 7,850 kg/m³, a Young s modulus of 200 GPa, a Poisson s ratio of 0.3, and isotropic hardening behavior characterized by a plastic strain of 0.065 at an ultimate stress of 370 MPa. Cyclic pushover analysis was conducted under incremental reversed loading in accordance with a specific protocol, and the base shear-displacement hysteresis curve was extracted. Subsequently, using the Priestley and Paulay method, the unidirectional pushover curve (initial loading branch) was idealized as a bilinear curve; based on Chopra’s equivalent energy principle, parameters such as the behavior factor, ductility ratio, overstrength factor, and initial stiffness were calculated. The results indicate that the calculated behavior factor for this frame is 1.99, and the ductility ratio is 1.39. These values ​​are significantly lower than the behavior factors proposed by the Iranian Standard 2800 (R=9) and ASCE 7-22 (R=8) for special moment-resisting frames. The primary reason for this discrepancy is insufficient ductility resulting from premature local buckling in the beam-column connection zone and the lack of adequate stiffeners in the webs and flanges of the sections. The distribution of von Mises stress and the pattern of yielded zones (AC YIELD) in Abaqus revealed the formation of the first plastic hinge in the flange of the right-hand column at a displacement of 6.9 mm and a force of 38 kN, resulting in an overstrength factor of RS = 0.624. This study demonstrates that Chopra’s method, combined with precise finite element modeling, is an effective tool for identifying actual structural weaknesses (such as limited ductility and premature strength degradation); unlike traditional bilinearization methods—which typically lead to an overestimation of capacity—it provides a realistic estimate of the behavior factor.

Keywords : behavior factor pushover curve chopra s method nonlinear static analysis steel moment resisting frame abaqus