Numerical Comparison of the Performance of Reinforced Concrete Piles Equipped with Inclined and Horizontal Reinforced Concrete Side Elements and Conventional Reinforced Concrete Piles in Saturated Clayey Soils, with the Aim of Reducing the Length and Cost of Conventional Piles
Numerical Comparison of the Performance of Reinforced Concrete Piles Equipped with Inclined and Horizontal Reinforced Concrete Side Elements and Conventional Reinforced Concrete Piles in Saturated Clayey Soils, with the Aim of Reducing the Length and Cost of Conventional Piles
Amin Rezaian1 Ali Sanjari2 Nahid Javadifar3
1) Assistant Professor, Department of Civil Engineering, Islamic Azad University, Gorgan Branch, Gorgan, Iran.
2) M.Sc. Student in Geotechnical Engineering, Department of Civil Engineering, Islamic Azad University, Gorgan Branch, Gorgan, Iran.
3) Assistant Professor, Department of Civil Engineering, Islamic Azad University, Gorgan Branch, Gorgan, Iran.
IOI Code
:
ABFG-ACAGHZ
Publication :
12th.international Congress on Civil Engineering, Architecture, Art and Urban Development(12icsau.ir)
Abstract :
In clayey soils, particularly soft and saturated clays, limited bearing capacity and high deformability may necessitate the use of deep foundations. However, increasing the length of conventional piles may lead to greater excavation volumes and material consumption. This issue becomes particularly significant when the groundwater table is high, as the excavation and construction of conventional concrete piles below the groundwater level become considerably more difficult and costly. This study numerically investigates the performance of reinforced concrete cylindrical piles equipped with inclined or horizontal reinforced concrete lateral elements, aiming to evaluate their potential to improve load transfer and reduce reliance on the length of conventional vertical piles. Three-dimensional finite element modeling was performed using ABAQUS software, and ten configurations were investigated, including vertical piles without lateral elements and piles equipped with one or two rows of lateral elements. The geometric variables included the length of the vertical pile, the length and inclination angle of the lateral elements, and the number of lateral element rows. The models were compared in terms of load–settlement curves, ultimate bearing capacity, and load-bearing performance relative to concrete volume. In the baseline group, the ultimate bearing capacity of the 7-m-long pile equipped with lateral elements was approximately 68.3% higher than that of the 7-m-long conventional pile without lateral elements and slightly exceeded the capacity of the 14-m-long vertical pile. In the second group, the two-row configuration with a 30-degree inclination angle exhibited the highest values for both performance indicators: load at 100 mm settlement and ultimate bearing capacity per unit volume of concrete. Nevertheless, inconsistencies in the model data and the absence of experimental validation limit the generalizability of the results. The findings indicate that the arrangement of lateral elements can influence the numerical performance of piles; however, further studies are required to evaluate their practical applicability and economic feasibility.