Experimental and Numerical Evaluation of the Behavior of Steel Shear Walls with Trapezoidal Corrugated Infill Plates under Cyclic Loading

Experimental and Numerical Evaluation of the Behavior of Steel Shear Walls with Trapezoidal Corrugated Infill Plates under Cyclic Loading

mahdi yosefi1

1) Master of Science in Civil Engineering, Islamic Azad University, Maragheh, Iran

IOI Code : ABKD-ACZHGA
Publication : Fourth International Conference on applied researches in civil engineering, architecture and urban planning (icarcau.com)
Abstract :
    Abstract Steel Plate Shear Walls (SPSW) have emerged in recent decades as an efficient and economical system for resisting lateral loads induced by wind and earthquakes. However, shear walls with flat infill plates are susceptible to out-of-plane buckling under service loads due to their low thickness, and the installation of transverse and longitudinal stiffeners entails high costs. In this research, the use of trapezoidal corrugated infill plates is numerically evaluated as a novel solution to enhance out-of-plane stiffness and eliminate the need for stiffeners. To this end, twelve numerical models were investigated using nonlinear explicit dynamic analysis in ABAQUS under cyclic loading, considering variables such as trapezoidal wave angle (20°, 30°, and 40°), wave orientation (horizontal and vertical), and infill plate thickness. The numerical model was first validated against reliable experimental results, demonstrating high accuracy. Parametric analysis results indicate that the maximum ultimate load capacity is achieved with vertical wave orientation at a 20° angle, which is approximately 10% higher than the corresponding horizontal case. On the other hand, the horizontal wave orientation with a 30° angle exhibited the highest energy dissipation (1.6% higher than the vertical case). Nevertheless, due to lower steel consumption and significant load capacity, the vertical orientation with a 20° angle is identified as the most optimal configuration. Furthermore, increasing the infill plate thickness by 20%, 40%, and 60% led to a nearly linear increase in both ultimate load and energy dissipation in both horizontal and vertical orientations.

Keywords : steel plate shear wall (spsw) trapezoidal corrugated plate cyclic loading finite element method (fem) energy dissipation ductility