Study of the elastic and plastic properties of anisotropic ultra-formable IF steel sheet

Study of the elastic and plastic properties of anisotropic ultra-formable IF steel sheet

Javad Rasti1 Fereshteh Heydari ne mat2

1) Assistant prof., Department of Mechanical Engineering, Qom University of Technology, Qom, Iran.
2) M.S. Student, Department of Mechanical Engineering, Khaje Nasiroddin Toosi University of Technology, Tehran, Iran

IOI Code : XADA-CAKEE
Publication : The 6th International conference of Sciences and Engineering(6icesconf.com)
Abstract :
    Due to its high formability, the IF ultra-formable steel sheet is widely used in the automotive industry and serves as an alternative to other steel sheets such as St14. In mechanical analysis of this sheet, such as vibrating, buckling and bending in simulation or modeling processes, it will be necessary to know the mechanical properties in the elastic and plastic regions. Many of the researchers, by simplifying, assume the properties of this sheet is isotropic, while the existence of directional properties in the sheet will lead to different results of simulation or analytical models with experimental ones. In the present work, the elastic and plastic properties of an IF steel sheet were investigated. The results of the tensile test showed that the sheet had anisotropic properties. Therefore, the four elastic parameters of this sheet, including Young s modulus and Poisson ratio, were obtained in two directions by tension tests and using the strain gauges. The shear modulus was also determined by the torsion test. In the plastic region, the yield locus were determined based on the quadratic Hill criterion and the earring parameter was also obtained.

Keywords : if steel sheet mechanical properties anisotropy hill criterion strain gauge