Low-noise low-noise amplifier design using a feed-back amplifier
Low-noise low-noise amplifier design using a feed-back amplifier
Farid Ferdowsi1 Peyman MirzaeiPour2 Dariush Bodaghi3
1) Department of Electrical Engineering, Faculty of Khorramabad,
2) Department of Electrical Engineering, Faculty of Khorramabad,
3) Department of Electrical Engineering, Faculty of Khorramabad,
IOI Code
:
XBFC-DDHKZ
Publication :
4th International Congress on Engineering, Technology and Applied Science - Auckland University of Technology(etas2019.com)
Abstract :
Each important part in the design of high-frequency integrated circuits is the low-noise amplifiers of the LNA. The LNA is a special type of electronic amplifier that is used to amplify the signals taken from the antenna, using the LNA causes the noise of the next classes to be reduced by LNA, but the LNA noise is injected directly into the received signal, In order to have the minimum amplifier noise, there must be a good boost in the first floor. Using CMOS transistor technology due to its low power capability, this technology is cheaper than other technologies and the high integration capability in the design of low noise amplifiers. The wider bandwidth of the amplifier also increases, so in The circuit responds well to a frequency of about 10 MHz, and has a gain of about 20 dB. This circuit is powered here with 0.18um technology and 1.8V supply voltage.
Keywords : low noise amplifier gain input matching noise number power consumption