Investigating and evaluating a jumper with a static analysis in ABAQUS software
Investigating and evaluating a jumper with a static analysis in ABAQUS software
omid shahbazi1 pooriya haji normohammadi2 vahid saberi3
1) Master of Science in Earthquake Engineering,
2) Master of Science in Earthquake Engineering,eyvanakey, Semnan, Iran,
3) Assistant Professor, Department of Civil Engineering, University of eyvanakey, Semnan, Iran,
IOI Code
:
XBFK-EZDHC
Publication :
2th. International Conference on Civil Engineering, Architecture and Urban Development Management in Iran(caumconf.com/2nd)
Abstract :
Beam is one of the main members in a set of elements used in construction structures. In fact, the main task of the beams is to withstand the stresses resulting from the shear force and the bending anchor due to the loads loaded on it and the weight of the beams. In the design of structures, the beams are usually designed based on the existing flexural anchor and the cut-off rule is controlled. The classification of musical members is usually done according to the type of loads applied to them. Typically, the maintenance of the beams is used as a criterion for describing and classifying these musical members. In this research, using an ABAQUS software, a stacked steel stacker is modeled. The results of tension and displacement results indicate the energy absorption and the hardness in the beam and the overspent graph is the result of a nonlinear static analysis that expresses the cross-sectional capacity behavior. Because the cross-sectional capacity was important, the undefined damage and failure, due to the material s material capacity, did not come intact, thus eliminating the element, the tear did not occur and the parts remained in the same plastic region. The results show the bearing capacity of the beam and its comparison in linear static analysis under the influence of pressure load and the creation of tensile stress in the beam.
Keywords : steel bar spark plug static analysis abaqus software