The effect of initial damage on the adhesion stress outside the elongation of rebar in normal and self-compacting concrete containing steel fibers

The effect of initial damage on the adhesion stress outside the elongation of rebar in normal and self-compacting concrete containing steel fibers

Ali Rostamian1 Mohammad kazem Sharbatdar2 Ali Kheyroddin3

1) Master of Structures, Faculty of Civil Engineering, Semnan University,
2) Professor of the Faculty of Civil Engineering, Semnan University,
3) Distinguished Professor of Civil Engineering Faculty, Semnan University,

IOI Code : XGFC-KAEFC
Publication : 8th.International Conference on Researches in Science & Engineering & 5th.International Congress on Civil, Architecture and Urbanism in Asia(8icrsie.com)
Abstract :
    In this article, using the test of pulling out the rebar from inside the cylindrical sample with ordinary concrete and fiber concrete containing 0.5% (micro) and 0.75% (macro) steel fibers, the adhesive stress between the rebar and concrete Conditions were evaluated in two normal and damaged states. Rebars with a diameter of 12 and 16 mm and a length of 5 times the diameter in a part of the length of 300 mm of the cylinder were connected with concrete and after 28 days of processing, they were subjected to a direct pull-out test. The damaged sample was first subjected to 20% of the final tensile capacity of the tensile strength, the initial load was applied and the initial cracks were created. Then it was subjected to the direct tensile load of the rebar. The effect of strength and microstructural properties of two types of concrete that were poured into molds in normal and self-compacting state were obtained and their effect on tensile strength and cohesion was investigated. The results of the conducted tests indicate that applying initial damage to fiber concrete samples caused the adhesion stress between rebar and concrete to decrease by 20%. Also, the amount of adhesion stress of the normal concrete sample was lower than that of the self-compacting concrete sample in the same compressive strength. Also, with the increase in the diameter of the rebar, the adhesion stress increased and the maximum increase was 20% with a diameter of 16 mm. Adding steel fibers to concrete samples increased the adhesive stress between rebar and concrete, which had the greatest effect on macro steel fibers with an increase of 18%. By applying initial damage to concrete samples, the adhesion stress of normal concrete is lower than that of self-compacting concrete, and the samples with macro steel fibers had the lowest amount of stress reduction among the samples with 11% reduction.

Keywords : adhesion stress fiber concrete self compaction initial damage