Distinct element analysis of wellbore stability in depleted reservoirs in UBD condition with attention to optimized production rate while drilling and minimum instability. Case Study: reservoir-A in Parsi oilfield.
Distinct element analysis of wellbore stability in depleted reservoirs in UBD condition with attention to optimized production rate while drilling and minimum instability. Case Study: reservoir-A in Parsi oilfield.
Aref Farahi1 Hossein Salari-Rad2 Behroz Ahmadi3
1) Iran amirkabir university of technology Email:
2) Iran amirkabir university of technology Email:
3) national iranian drilling company Email:
IOI Code
:
XYAD-ZCCKD
Publication :
2nd International Conference On Research Science And Technology(2rstconf.com)
Abstract :
The main concern in this study is utilizing distinct element numerical modeling in simulating underbalanced drilling (UBD) of parsi oilfield in south west of Iran, using UDEC commercial codes. Parsi oilField is one of the biggest fractured carbonated oilfields in south west of Iran. This field is always plunged to problems such as loss and pipes stuck in the wells. The main cause of pipe stick in drilling wells of this field is aggregation of drilling cuttings around pipes caused by speed reduction of drilling fluid and reduction of their carriage capacity in shale sections which are destructed and collapsed.
The reports presented of this well, demonstrate that drilling in 16.2-16.24 MPa bottom hole pressure with 130 bbl/hour production of crude oil while drilling, provide stability of zones of reservoir in the well.
Numerical simulation of underbalanced drilling of this well using UDEC indicated that by paying attention to drilling fluid’s loss and breakout, optimized range for drilling mud pressure in the pay zones is 17-17.35 Mpa, by assuming that production rate is 20 bbl/hour during drilling and reservoir’s fluid flow is transient. By comparing results of this study with daily reports and prepared logs of this well, it can be concluded that in fractured reservoir wellbore stability is influced by production rate while drilling. And more stability is the result of higher production rate, so lower pressure is required for wellbore stability in UBD condition. Furthermore, transient flow of reservoir’s fluid is more realistic than steady state flow in modeling.
Keywords : under balanced drilling technique production while drilling distinct element method (udec) well bore stability parsi oilfield