Investigating the Effect of FRP Flexural Strengthening Sheet on Crack Distribution in RC Beams with lowest steel ratio
Investigating the Effect of FRP Flexural Strengthening Sheet on Crack Distribution in RC Beams with lowest steel ratio
Ali Azizi1 M.R. Tavakkolizadeh2
1) Master of Science in Structural Engineering of the Islamic Azad University of Mashhad, Email: Aziziali (dot) en (at) gmail (dot) com
2) Assistant Professor Department of Civil Engineering Faculty of Engineering Ferdowsi University Of Mashhad (FUM), Email: drt (at) um (dot) ac (dot) ir
IOI Code
:
XYCE-ACFAK
Publication :
International Conference on Civil Engineering, Architecture and urban infrastructure(icica.ir)
Abstract :
This study is Investigating the Effect of FRP Flexural Strengthening Sheet on Crack Distribution in RC Beams using finite element software Abaqus Using Finite element method software model. Methods such that the software Abaqus one of the specimens reinforced concrete without steel reinforcement FRP and one of the specimens reinforced by sheet FRP under load bending four points of the model and results with the results obtained from samples The laboratory has matched. 9 specimens were further reinforced model number, spacing and height of at least a minimum of cracks occurring in each series of tests was to determine. By increasing the number of layers of FRP from one to three, indicating lack of ductility of concrete beams, and to crack growth by bending increases, and also the connection layer of FRP increases the number of leave that an increase in Youngs modulus layer growth is very high because it increases the stiffness of the beam.
Keywords : frp crack pattern modeling reinforced concrete beams