Synthesis Alloy System Ti-base by Mechanical Alloying and Annealing Heat treatment
Synthesis Alloy System Ti-base by Mechanical Alloying and Annealing Heat treatment
Milad Tahmasebi1 Hamid Khorsand2
1) Khaje nasir toosi university and technology of Tehran, Iran:
2) Khaje nasir toosi university and technology of Tehran, Iran:
IOI Code
:
XYCZ-AAFHA
Publication :
International Conference on Engineering and Applied Science(iceasconf.com)
Abstract :
Ti,Zr-based solid solution was successfully synthesized by mechanical alloying process with nominal composition of 37.5Ti-37.5Zr-15Cu-10Ni (% wt.) using a high energy planetary ball mill. The alloyed powder is applicable as filler alloy and reinforcement agent for fusion surface hardening of some strategic metals and composites. The milling process was performed at 250 rpm along with different milling times (5, 10, and 15 h). Nanocrystalline intermetallic compounds were generated by annealing process via a home-grown infrared tube furnace providing heating rate of 200 °C/min. Infrared radiation releases high volume of energy in a short time to the surface powder. Therefore it does not change the entire Nanocrystalline microstructure. Powders were characterized using X-ray diffraction method and scanning electron microscope. The crystallite size, lattice strain and lattice parameters were determined at optimum milling time (10 h) as 13 nm, 0.4 % and 2.7 nm, respectively. Micrographs revealed that the morphology of the powders has been deformed during the milling process. Some of intermetallic phases such as (Ti/Zr)Cu, (Zr/Ti)2Cu and (Ti/Zr)Ni were generated after annealing at 750 °C for 15 min at argon atmosphere.
Keywords : mechanical alloying annealing heat treatment nano stracture scanning electron microscopy x ray diffraction