optimization of parameters of friction stir welding by taguchi method based on taguchi method
optimization of parameters of friction stir welding by taguchi method based on taguchi method
Hashem roodi1 Khalil Khalili2 Seyed yousof ahmadi borooghani3
1) university of birjand Email:
2) university of birjand Email:
3) university of birjand Email:
IOI Code
:
XYCZ-AAHHA
Publication :
International Conference on Engineering and Applied Science(iceasconf.com)
Abstract :
The goal of this article is optimization of stress intensity factor (KI-factor) effected by friction stir welding (FSW) of 5083 aluminum plates. Taguchi method is used to design of experiments (DOE) to optimize welding parameters including pin rotational speed, welding progress speed, spindle angel and the ratio of the shoulder diameter to sheet thickness. The optimization process depend on effect of the welding parameters on K-factor. E399 standard is used to experimental tests. CT model is used to design the experiment particles and K factor is calculated. A signal to noise ratio is employed to choose the optimum level of parameters. By using statistical analysis of variance (ANOVA), the most significant parameter on K factor is determined. The significant parameters are welding speed, rotational speed and shoulder diameter while angular deviation of spindle less effect. The rotational speed variation leads to incrise or decries the heat generation of welding which affects on K factor. The welding speed variation leads to change heat generation to location rate which affects on K factor too. The shoulder diameter variation leads to change friction surface which affects on heat generation and K factor. The angular deviation of spindle variation leads to uniform surface of welding and decries defects.
Keywords : friction stir welding k factor taguchi method