3D Numerical Simulation of Shell and Tube Heat Exchangers to Optimization Performance
3D Numerical Simulation of Shell and Tube Heat Exchangers to Optimization Performance
javad khani marghzar1 Hesamoddin Salarian2 Qhadir Esmaeili3
IOI Code
:
XYCZ-AAKFC
Publication :
International Conference on Engineering and Applied Science(iceasconf.com)
Abstract :
Abstract
Nowadays, the shell and tube heat exchanger is one of the most common type of heat exchanger which is widely used in the oil industry and other major chemical processes, as it is suitable for high pressure processe and apllications. In this thesis, a shell and tube heat exchanger including 70 tubes and one shell having 5475 mm length and 480 mm diameter is numerically modeled. Using Computational Fluid Dynamics (CFD) technique, the temperature and velocity profile in tubes and shell are investigated. Such a heat exchanger is used in the boiler plant of North Oil Terminal in order to preheat the water entering into the boiler. In this exchanger, a refrigerant with higher temperature (i.e., the back steam) and a refrigerant with lower temperature (i.e., the water entring into the boiler), which the temperature of both refrigerants are already known, are passing indirectly close to each other and the heat is exchanged. The CFD simulation process of this shell and tube heat exchanger includes the geometry modeling, meshing, and solving the model using ANSYS software. The results of the CFD modeling are compared with the obtained experimental results. Subsequently, the calculated error is about 6.29 % which is an acceptable error. of Realizable k-ε model with standard wall functions are employed to analyze such a heat exchanger. The temperature distribution inside two tubes (one on top and the other at the center of the tube) has been evaluated and it has been observed that there is a temperature difference in the both tubes which are located in a same position. Based on our achievment, the design of corresponding heat exchanger needs to be modified in order to be more efficient in term of heat exchange.
Keywords : heat exchanger shell and tube simulation performance fluent