using FLOW3D in Numerical modeling of spatially varied flow in three dimensions

using FLOW3D in Numerical modeling of spatially varied flow in three dimensions

alireza bakhshi1 keyvan bina2

1) Department of hydrualic structure ,Science and Research Branch, Islamic Azad university, Tehran, Iran
2) Department of Hydrulic Structure , college of civil , kish international Branch, Islamic Azad University, kish, Iran.

IOI Code : XYGD-BCHEZ
Publication : The 5th International conference of Sciences and Engineering(5icesconf.com)
Abstract :
    Many of hydraulic engineering problems are complex and require a three-dimensional flow analysis. With the development of increasingly powerful computers and enabling the development of numerical models which can simulate the flow and transport equations numerically analyze complex geometries is in disarray. Numerical modeling of software engineers is inevitable to do. Test samples in order to achieve optimum physical parameters affecting the flow field, which is required to perShape several experiments with different work orders, and also very expensive and time limitations. In addition to human errors, instrument errors of the other cases the causes of complex hydraulic structures. One of the most common methods of numerical simulation is used in water structures. In the present study was carried out Flow-3D v10 software for numerical simulation laboratory experiments Righetti Lanzoni and (2008) which has been conducted in the intake bottom. Also, the best model of turbulent transport (RNG) for numerical modeling of these type of intake presented according to the results. The results show very good perShapeance and acceptable coefficient of determination between the numerical model and the experimental observations and the numerical results of about (R2=0.98) obtained. This study was carried out in a total of 81 new series run with different hydraulic conditions on the grid bottom of the structure. By using data obtained from each run, the coefficient of discharge bottom grid, were studied under various parameters which effected on hydraulic and geometric. For this purpose, using dimensional analysis, extracting the dimensionless relationship between the dependent and independent variables and then the data from the experiments were fitted to a proper relationship. In this research, discharge coefficient fitting equations to estimate flow rates at different grid bottom, were compared with relationships obtained by previous researchers.

Keywords : واژگان کلیدی مدل سازی سع بعدی مشبک جریان آب