Joining of Inconel 600 to AISI-316L austenitic stainless steel by Micro plasma arc welding For use in the aerospace industry

Joining of Inconel 600 to AISI-316L austenitic stainless steel by Micro plasma arc welding For use in the aerospace industry

morteza poorghorban1 behroz movahedi2 mojtaba poorghorban3

1) Iran, Daneshpajoohan Higher Education Institute,
2) Iran University of
3) Iran, University of Applied Sciences25 of

IOI Code : XYGE-BDAKE
Publication : 3rd International Conference on Engineering and Applied Science (3iceasconf.com)
Abstract :
    The microstructure of the function of metals and welding effectseSpecially dissimilar joints in aeroplane Industries Thatisamatter of great importance in this article the process of microplasma welding on Inconel600 with Austenitic stainless steel has been shown.Empirical samples with voltage current, speed of welding, heat affected zone and through volumetric rates of protected gas under welding has been conducted amounts of optimal values and parametrs has been determined.Conducted expriments are tensile, hardness, Non-defective tests,metallography, SEM, linear analysis (EDX) and spot analysis (XRF).After getting the results ,microscopics and mechanical tests and examining the design of the systems the most important factors affecting the welding are designing the joint, designing the system and not observing appropriate welding has been detected.In this method not to use a metal After visual inspection and detecting in penetrant, the location of welding has been examined to detect if there is a crack or not. micro structure of different locations include welding metal, heat aaffected zone and shared distances by the use of light microscope has been exzamined. the results showed that infrastructural and metalogical changes had happened in the welding metal zones and het affected zones. That leads to the conclusion that the best frequencyfor welding was 200 HZ and its heat affected zone has been less comparing to other samples and For metals are low melting temperature difference can be made without welding filler metals.Experiments show that doing detente operation after welding causes consistency and hardness of the samples and also more stability of hardness in different zones

Keywords : microstructure aisi 316l inconel 600 dissimilar welds heat affected zone