Comparative study of factors affecting the vibration of the steering wheel when braking and roots on the disc KIA MOTOR AND BOSCH

Comparative study of factors affecting the vibration of the steering wheel when braking and roots on the disc KIA MOTOR AND BOSCH

Shahram Shahriari1 Amin zarnani2 Behrouz Torabi3

1) Dr. Mechanical Engineer and chassis department management of AIRIC Email:
2) M.sc. Mechanical Engineer of AIRIC Email:
3) M.sc. Metallurgical Engineer of AIRIC and Tehran Polytechnic Email:

IOI Code : XYZG-ZABKA
Publication : 2nd International Conference on Science and Engineering(2icesconf.com)
Abstract :
    In this article the root causes of the steering wheel vibration during braking was discussed. The results of this study are that the main cause of vibration in the steering wheel of the car was differential disk thickness that was in out of limitation disc thickness. Observations and studies show the amount of differential disk thickness of criticism caused in the production process (turning) but the run out of disc brake vehicle can increase differential thickness of the disc by mileage. Another survey result, identify deviations of brake disc hub and be out of the range surface orthogonal plane to the axis of rotation as a cause or increase the amount of disk run out. Run out caused by heat of a brake disc as a result of successive braking can also be increased, to avoid heat stress in brake disc should be taken heating process on disc brakes. One of the important causes of run out problems in the hub was in process of pressing the brake disc bolts in the hub of the wheel. Improper pressed of bolts caused a slight distortion in the area on the disc hub and subsequently caused an impermissible run out in disc and hub set. The results show that the main causes of this phenomenon, which was the hub of the production process and pressing which it has been discussed in this article.

Keywords : brake disc and hub wheel vibration run out of disc microstructure micro hardness