The effect of dielectric types on the machining Characters in EDM process

The effect of dielectric types on the machining Characters in EDM process

Mohammad Reza Shabgard1 Hadi Eivazi Bagheri2

1) Department of Mechanical Engineering, University of Tabriz ,Tabriz, Iran
2) Young Researchers and Elite Club, Tabriz Branch, Islamic Azad University, Tabriz, Iran

IOI Code : XYCC-ABFBG
Publication : International Conference on Science and Engineering(icesconf.com)
Abstract :
    This paper studies, the effect of Dielectric type (kerosene oil and De-ionized Water) on the output parameters (material removal rate, tool wear ratio, surface roughness) in electrical discharge machining (EDM) of -TiAl intermetallic compounds. The results showed that increasing pulse current and pulse on time in both of dielectric fluids has upward trend on material removal rate and with using kerosene dielectric the material removal rate is always higher and tool wear ratio is lower than the one with de-ionized water. Also Surface roughness of machined parts in kerosene at low pulse current is less than the machined ones in de-ionized water.

Keywords : edm γ tial dielectric pulse on time pulse current