Effect of geogrids modulus of elasticity on bearing capacity ratio

Effect of geogrids modulus of elasticity on bearing capacity ratio

saman sadeghi1 mehdi siavoshnia2 seyed mohammad farid astaneh3

1) Department of Civil Engineering, Islamic Azad University, Central Tehran Branch, Iran.
2) Assistant Professor, Department of Civil Engineering, Faculty of Engineering, Islamic Azad University, Central Tehran Branch, Iran.
3) Assistant Professor, Department of Civil Engineering, Faculty of Engineering, Islamic Azad University, Central Tehran Branch, Iran.

IOI Code : XYCZ-AAHAA
Publication : International Conference on Engineering and Applied Science(iceasconf.com)
Abstract :
    A group of finite element analyses was carried out to investigate into the ultimate bearing capacity of the square footing on sand with and without geogrid reinforcement. Simulations were conducted with dimension of 12*12*6m to construct 3D media. The parameters investigated are the effect of the depth of single layer of geogrid, number of geogrid layers within the reinforced zone and length ofreinforcements. Influence of all these parameters on the bearing capacity improvement of square footing and its settlement is studied by comparing with the simulation on unreinforced sand. The results proved that the reinforcements had a considerable effect on the ultimate bearing capacity of the square footing on a sand bed. Based on the finite element analyses, optimum values of geogrid parameters for maximum reinforcing effect are discussed and suggested.

Keywords : finite element bearing capacity square footing geogrid