A Review of the Analysis of Heat Treatment Parameters (Intercritical Austenitizing Temperature and Time, and Tempering Temperature) on the Microstructure and Hardness of C80W1 Steel

A Review of the Analysis of Heat Treatment Parameters (Intercritical Austenitizing Temperature and Time, and Tempering Temperature) on the Microstructure and Hardness of C80W1 Steel

Mohammad Jiryaei1 Abdollah Kazemi2

1) Master of Science in Mechanical Engineering, Manufacturing and Production Orientation, Faculty of Engineering, Islamic Azad University, Aligudarz Branch, Iran
2) Master of Science in Mechanical Engineering, Manufacturing and Production Orientation, Faculty of Engineering, Islamic Azad University, Aligudarz Branch, Iran

IOI Code : ACCD-ACZHHG
Publication : 10th International Conference on Applied Researches in Science & Engineering (carseconf.com)
Abstract :
    Carbon tool steels are widely used in the manufacture of various cutting tools, dies, punches, and components employed in the manufacturing and production industries due to their hardenability, relatively low cost, and the possibility of achieving suitable mechanical properties through heat treatment. Steel 1.1525, known as C80W1 in the DIN standard and C80U in the EN standard, is among the carbon tool steels whose mechanical and microstructural properties are strongly influenced by heat treatment parameters. The aim of the present paper is to review and analyze the role of austenitizing temperature and tempering temperature in the microstructural evolution and hardness changes of this steel. In this regard, the metallurgical fundamentals of austenitization, quenching, retained austenite formation, and tempering are examined, and the results obtained from an experimental study conducted on 1.1525 steel samples are also analyzed. In the experimental study, six heat treatment conditions were investigated, including three austenitizing temperatures of 760, 800, and 840 °C and two tempering temperatures of 180 and 280 °C. The samples were austenitized for 8 minutes, quenched in a boiling 10% brine solution, and then tempered for 192 minutes. Microstructural examination was performed using an optical microscope, and hardness measurement was carried out by the Rockwell C method. The results showed that the austenitizing temperature has a much greater effect on the core hardness of the part compared to the tempering temperature. The average hardness increased from about 21.5 HRC at an austenitizing temperature of 760 °C to the range of 24.7 to 27 HRC at 800 °C and 37.3 to 46.4 HRC at 840 °C. Microstructural examination also showed that increasing the austenitizing temperature leads to increased dissolution of carbides and a gradual change in structure from mainly pearlitic structures to structures containing bainite and martensite. Despite the significant increase in hardness at 840 °C, the final hardness value is still lower than the potential hardness reported for this steel, which can be attributed to its inherently low hardenability, the short austenitizing time, and the relatively low severity of the quenching medium.

Keywords : steel 1 1525 c80w1 heat treatment austenitization tempering quenching microstructure hardness martensite retained austenite