Comparison of efficiency of modified zeolites by cationic surfactant and iron nanoparticles in water nitrate removal
Comparison of efficiency of modified zeolites by cationic surfactant and iron nanoparticles in water nitrate removal
marzeih akbari1 akram bamani2
1) Master s student in environmental pollution, Department of Environmental Sciences and Engineering, Faculty of Agriculture and Natural Resources, Ardakan University
2) Assistant Professor, Department of Environmental Sciences and Engineering, Faculty of Agriculture and Natural Resources, Ardakan University, email:
IOI Code
:
XGKB-KEFGC
Publication :
Conservation of Natural Resources & Environment along with Forests of Iran(envprouma.ir)
Abstract :
Nitrate pollution of water resources is one of the most important environmental problems of today, nitrate is the most common non-concentrated pollutant of water resources. The permissible concentration of nitrate according to the standard of the World Health Organization is 50 mg/liter, the concentration of nitrate exceeding the standard in water causes methemoglobinemia and cancer of the human digestive system and the phenomenon of nitrification. Considering the adverse effects of nitrate in water, one should look for a method to remove or reduce it, among these methods include surface absorption, ion exchange, reverse osmosis, electrodialysis, chemical regeneration, and purification, which is a surface absorption method with cheap absorption. Available, biofriendly, porous, high absorption capacity and reusability is the most effective method. Zeolite is an adsorbent that has all these characteristics, due to the negative surface charge of this adsorbent, natural zeolite is not very effective in removing organic pollutants, so it is necessary to modify the surface of zeolite. In this research, the amount of nitrate removal from water by zeolite modified with cationic surfactant and zeolite modified by iron nanoparticle was compared based on the studies done and the effective factors in the nitrate absorption process (contact time, adsorbent dose, initial nitrate concentration and pH) were investigated. Based on the results obtained in the studies of two acidic pH modified zeolites, increasing the contact time and adsorbent dose increased the nitrate removal rate and increasing the initial nitrate concentration decreased the nitrate removal rate. According to the calculations of the absorption isotherm parameters of the adsorbents, it was found that the zeolite modified with iron nanoparticles had a better efficiency in nitrate removal.
Keywords : nitrate surface adsorption modified zeolite iron nanoparticles cationic surfa