Investigation and comparison of the amount of tensions applied on the timing belt at the moment of teeth separation from the bed in the Pride and xu7 engines in different materials of CR, HNBR and EPDM with various number of tensile members
Investigation and comparison of the amount of tensions applied on the timing belt at the moment of teeth separation from the bed in the Pride and xu7 engines in different materials of CR, HNBR and EPDM with various number of tensile members
Mohsen Roholamin1
1) 1. MSc student, Department of Mechanical Engineering, Iran University of Science and Technology
IOI Code
:
XBHB-DHHFK
Publication :
International Congress of Science and Engineering - TOKYO UNIVERSITY - JAPAN(tuicet.com)
Abstract :
Camshaft using the timing belt. In general, automotive companies announced that the time to replace the timing belt in best conditions is over 120,000km, but driving in undesirable conditions reduced the life of timing belts. If the timing belt is torn or slide, it caused engine to stop and even caused serious damages to it. When timing belt is torn during the motion, there will no special things happened, but in any case, if the car is turned off during the motion, it would not be turned on at all, because in some cars (like Persia or higher model cars) it caused the camshaft to be titled. The amount of tensions applied on the timing belt at the moment of teeth separation from the bed in the Pride and xu7 motors in different materials of CR, HNBR and EPDM with various number of tensile members.
Keywords : cr epdm hnbr timing belts xu7 engines